Network Technologies SE-DVI-2 Operation, Power Connector, LED indicates, Source at, Video

NTI VIDMUX Series 2-Port DVI Video Switch

4.Plug the 5VDC AC adapter into the power jack on the rear panel.

Rear View of SE-DVI-2

Monitor Video 2 Video 1

5VDC +

NTI	R	NETWORK
		TECHNOLOGIES
		INCORPORATED
1275 Danner Dr		Tel:330-562-7070
Aurora, OH 44202		Tel:800-742-8324

www.networktechinc.com

Barrel	5 VDC
	AC

ADAPTER

Power Connector

5VDC @ 2.0A OUTPUT

(Outside	(Inside
barrel)	barrel)

2.1mm x 5.5 mm Female

5.Power up the VIDMUX first.

6.Power up the monitor.

7.Power up one or both of the video sources.

Note: If one or both of the video sources is a PC, make sure the LED associated with that source is illuminated while the PC boots up. Otherwise the PC may not properly initialize with the connected monitor. See OPERATION below.

OPERATION

Press the input select buttons to switch between video sources. The LED above each button will illuminate to indicate which

source is connected to the monitor. Only one source can be connected at a time.

Note: While booting up a PC, it is recommended that the monitor be connected to the PC (corresponding LED should be illuminated) in order for the PC to properly initialize with the connected monitor.

Front View of SE-DVI-2

R	LED indicates
NetworkNTITechnologies Inc
VIDMUX R	Source at
	VIDEO 1
1	is connected
	2

3