New Holland FP240 specifications New Holland, Pull-Type Forage Harvester Specifications, Page 1of

New Holland

Pull-Type Forage Harvester Specifications

790	FP230	FP240
MODEL			790	FP230	FP240
Weight (single axle), lbs. (kg)			3104 (1411)	4500 (2040)	4700 (2130)
Length, ft. in. (m)			16’ 1-1⁄4” (4.98)	................................................................	21’ 6” (6.5)
Height with standard spout, ft. in. (m)			10’ 6” (3.2)	.....................................................................	11’ 2”
Width, ft. in. (m)			9’ 6” (2.79)	................................................................	10’ 8” (3.3)
Number/type of knives				12 single-edge hardened alloy
Cutterhead, type/speed				Cylinder, 850 rpm
Cutterhead, diameter, in. (mm)			19-5⁄16 (490.5)	.................................................................	21 (533.4)
Throat opening, in. (mm)			19 x 4-5⁄8 (482 x 117)	22 x 6-5⁄8 (558.8 x 167.7)	24-3⁄8 x 6-5⁄8 (619.76 x 167.6)
Shearbar			Quick adjust, reversible, hard-faced on vertical and horizontal surfaces
Length of cut, in. (mm)*			1⁄8 to 1-1⁄2 (3.2 to 38.1)	....................................................3⁄16 to 7⁄16* (4.8 to 11.1)
Blower speed			1000 or 750 rpm		1000 rpm
Recommended max. tractor hp			150 PTO hp	225 PTO hp	300 hp
Minimum power required			75 PTO hp	150 PTO hp	180 PTO hp
Knife sharpener			2” manual, built-in		3” manual, built-in
Recutter screens (non processor units)			5 sizes available		6 sizes available
Vertical wheel adjustment, in. (mm)			4-1⁄2 (114)		6 (152)
Tire sizes, single axle			11Lx14 6PR standard	31x13.5-158PR standard	14Lx16.1 8PR standard
			31x13.5-156PR optional	14Lx16.1 8PR optional
Tire sizes, tandem axle			N/A	11Lx15-156PR	11Lx15-15 6PR

*Longer lengths of cut can be obtained by removing knives—up to 1-5⁄16” length of cut with only four knives.

Optional CropPro™ Crop Processor	Not available	...................................................................	Optional
Construction	—	...............................................Hardened ductile iron, steel shaft
Weight, lbs. (kg)	—	490 (218)	520 (231)
Roll width, in. (mm)	—	24-1/2 (622.3)	26-7⁄8 (682.6)
Roll diameter, in. (mm)	—	.................................................................	7-7⁄8 (200)
Roll gap, in. (mm)	—	......................................................	3⁄16 to 5⁄8 (4.8 to 15.9)
Roll speed	—	............................................................	2650 rpm upper
		.............................................................	2250 rpm lower

Page 1of 2