NewAir 9701i, 9715i, 9720i, 9700i user manual INSTALLER settings continued

20

INSTALLER settings (continued)

AUXILIARY HEAT

STANDARD - COMP. =ON

ADD ON - COMP. =OFF

INSTALL MENU	SELECT
RESIDUAL COOL
SECONDS DELAY		60
INSTALL MENU	SELECT
BALANCE POINTS
LOW BALANCE		45	˚F
HIGH BALANCE			˚F
		95
INSTALL MENU	SELECT
AUTO CHANGEOVER
DISABLE
ENABLE
INSTALL MENU	SELECT

AUXILIARY HEAT

The 9720i can be set to use your 2H/2C heat pump internal auxiliary heating or to use an external add-on source. The add-on feature will be used most often when a single stage heat pump uses a gas or electric furnace as its second stage of heating.

RESIDUAL COOL

In order to get greater efficiency from the cooling system, the fan can be programmed to run for 0 (OFF), 30, 60, 90, or 120 seconds after the air conditioner has shut off.

BALANCE POINTS

This screen will appear only when the optional outdoor sensor (9025i) is connected to the thermostat. When this sensor is used with the 9720i, you can set the lower and upper temperatures to disable or enable 2nd stage heat.

AUTO CHANGEOVER

When turned on, the thermostat will switch automatically between heating and cooling to maintain the optimal temperature in your home.