NewAir AW-210ED instruction manual Operating Your Wine Cooler, Care and Maintenance

Operating Your Wine Cooler

It is recommended that the wine cooler be installed in an area where the ambient temperature is between 10-26ۦ C (50- 80° F). If the ambient temperature is above or below the recommended ranges, the unit’s performance may be affected, and extreme cold or hot conditions may cause the interior temperature to fluctuate. This will then prevent the optimal range of 10-16 ° C (50-60° F) from being reached. In addition, keep in mind that the temperature may fluctuate depending on whether the interior light is on or off, and whether the bottles are located on the upper, middle, or lower racks.

How to Use the Buttons on the Display Panel:

The desired temperature and light can be set by pressing the buttons on the display panel. The two buttons on the panel - “” and “” - adjust the temperature in increments of 1° C between 7-18° C/10-18° C (44-66° F/54-66° F). You can also turn the interior light on or off by pressing the “Light” button.

Care and Maintenance

Cleaning Your Wine Cooler

zUnplug the wine cooler and remove any bottles.

zWash the inside of the unit with a warm water and baking soda solution consisting of approximately 2 tablespoons of baking soda to one quart of water.

zPull out the water box at the bottom and rinse.

zTo clean the outside of the unit, use a mild detergent and warm water.

Moving Your Wine Cooler

zRemove any bottles.

zSecurely tape down all loose parts located inside the unit.

zTurn the leveling feet up to the base in order to avoid damage.

zTape the door shut.

zBe sure the wine cooler stays in an upright position during transportation.