Newcon Optik LRB 7X50 operation manual Supplied Accessories

1

Patent pending

Newcon Optik

Made in Canada

9

10

1 – Eyepieces; 9 – Interpupilary distance adjustment lever

10- Identification Label (Located on the Bottom)

Fig. 2

3. SUPPLIED ACCESSORIES

LRB 7X50 is supplied in the following assembly:

- Device	1 pc.
- Carrying Case	1 pc.
- Neck Strap	1 pc.
- User’s manual	1 pc.
- Warranty card	1 pc.
- 9V battery (optional)	1 pc.

•TARGET REFLECTION MED - when the number of steady received reflected signals is in medium range and enough to make positive conclusion about the measured distance;

•TARGET REFLECTION HIGH - when the number of steady received reflected signals is qualified to be enough to make reliable conclusion about the measured distance.

The displayed statistical qualification of the reflected signal characterizes variation in expected accuracy of measurements. At qualification HIGH the accuracy of measurements is stated as

±1m or ± 0.1%. At lower rates of statistical qualification the expected accuracy may marginally degrade.

Please note: this is an optional feature.

The display presents message LOW BAT – when voltage of the primary 9-volt battery drops below 7.2 volt. At this point the System is still functional but the battery should be replaced as soon as possible. The system can operate at the voltage levels above 7 volts.

The System remains in the active displaying state for 10 seconds after pressing of any of the operating buttons and after 10 seconds enters the passive low power state.

Alkaline or lithium type of batteries capable to sustain current drain up to 150 ma should be used for powering the System.