Newcon Optik TVS 7B user manual Description, External Power Pack

DO NOT POINT THE TURNED ON DEVICE

4Description

9	2	9		4
1				3
8				5
6			7

1.ON/OFF Power Button Switch

2.Left & Right Eyepieces with Rubber eyecups*

3.Manual Brightness Control (override) of displays.

4.Digital Zoom Button Switch

5.Universal Service Connector (see details on page 4)

6.Front lens with Focusing Ring

7.“Black hot-white hot” Button Switch (“BH-WH”)

8.Battery Compartment Cover

9.Dioptric Adjustment Rings.

*Interpupillary adjustments between eyes. Slide<-> or >-<

External Power Pack.

Very convenient for long time or cold weather operation. Comes with high capacity Li-Ion batteries and universal charger. Good for up to 8 hours of continuous work.

Caution! When external battery pack is in use strictly recommended to remove 2 pcs. of AA batteries from battery compartment. Leaving them inside will cause overheating of the device and/or batteries which would cause batteries leakage and power drain from the exter- nal battery pack. Battery Pack has red LED which is ON when connected to TVS 7B. Universal 110-250 V charger is included.

IMPORTANT NOTICE. USE OF IMPROPER BATTERIES OR VOLTAGE MAY SERIOUSLY DAMAGE DEVICE WITH NO WARRANTY COVERAGE FROM US!

How To Do It 5

This is the short description how to operate TVS 7B. Read carefully to make sure you fully understand how to power up your Thermal Imager properly.

TVS 7B needs minimum 2.4 V and Maximum 3.3 V, therefore Use only Lithium type 2 pcs. AA batteries (1.5V each) or at least 2500 mAh Rechargeable batteries AA size (1.2V each).

To begin with, install batteries into battery compartment

(8)complying with polarity guidance (-)inside, (+)outside. Remove cover from the front lens and switch Power But- ton into position ON. Clicking sound in the beginning of usage is normal for thermal core. By turning and moving Dioptric Adjustment rings (9) adjust diopters and dis- tance between eyepieces to satisfy the user eyes’ visual acuity for the system’s best performance. Observing the object adjust focus by turning front lens (6).

With optional Video-Out-to USB adapter and soft- ware the video signal from Thermal Imager can be trans- ferred to the computer and stored for tactical purposes.

Video-Out cable.

Allows to connect TVS 7B to any standard RCA Video- In (monitor, TV, VCR etc.)

Video-Out-to USB adapter and software.

Allow to transfer images into digital format for further transfer to a computerized fire control system.

NOTE. All technical description and features of the product are subject to change without prior notice.

ATTENTION!

TO THE BRIGHT LIGHT SOURCE! IN SOME CASES LIGHT OVERLOAD MAY CAUSE IRREVERSIBLE REDUCTION OF I.I.T. OR F.P.A. RESPONSIVITY OR PERMANENT DAMAGING.