ASSEMBLY INSTRUCTIONS
Side burner valve assembly:
Step 1: Insert valve assembly through side panel
Valve
(Side panel, right #29)
Step 3: Insert valve stem assembly into burner venturi
Step 2: Remove 4(four) screws & washers from the “U” brackets on the side burner
(#22)
Step 4: Insert valve stem assembly through knob hole to the control panel
Valve Stem
Valve
(Control Panel #22)
Step 5: Replace “U” brackets with 4(four) | Step 6: Align & tighten knob bezel & valve |
Screws( DO NOT TIGHTEN) | stem with 2(two) screws & washers |
| as shown below. |
| (knob bezel in bag) |
#22
Step 7; Tight all 4(four) screws on the “U” brackets on the burner, then connect the ignition wire on to valve.
Step 8: Place knob on valve stem, then screw the knob by using the wrench tool.
(Wrench tool enclosed in bag )
(Ignition wire)
8
