NX Wind transducer set | English |
4 Pairing procedure of wind transducer
When all instruments have been installed, a pairing procedure between the wireless wind transducer and the WSI unit must be made to introduce it to your specific NX network system. This is how you do it:
a.Make sure the wind transducer is fully charged!
If the wind transducer has been stored in a dark place for a long time, you must first charge it by exposing the solar cell for sun light some hours before use.
b.Pairing!
Hold the wind transducer within 2m from the Wireless WSI unit, and then press the INIT button (through the hole in the bottom of the battery lid) by use of the “pin”.
If the batter lid is open, you may see the LED. The built in LED will flash 2 times then lit for 2s, before it is turned off. Your Nexus system is now ready for use.
If the pairing of some reason did not work, the LED will flash a third time. You should then release the
5 Re-initialization of the wind transducer
To release the Wind transducer and
The wind transducer can then be
när den åter skall monteras. Se procedur enligt ovan.
6 Maintenance!
7
