Nikon COOLPIXS210P, COOLPIXS210CB manual Cleaning, Storage, 119

Caring for the Camera

Cleaning

	Avoid touching glass parts with your fingers. Remove dust or lint with a blower
	(typically a small device with a rubber bulb attached to one end that is
	pumped to produce a stream of air out the other end). To remove fingerprints
Lens	or other stains that cannot be removed with a blower, wipe the lens with a soft
	cloth, using a spiral motion that starts at the center of the lens and working
	toward the edges. If this fails, clean the lens using a cloth lightly dampened
	with commercial lens cleaner.
Monitor	Remove dust or lint with a blower. To remove fingerprints and other stains,
	clean the monitor with a soft, dry cloth, being careful not to apply pressure.
	Use a blower to remove dust, dirt or sand, then wipe gently with a soft, dry
	cloth. After using the camera at the beach or seaside, wipe off any sand or salt
Body	with a dry cloth lightly dampened with fresh water, then dry thoroughly. Note
	that foreign matter inside the camera could cause damage not covered by the
	warranty.

Do not use alcohol, thinner, or other volatile chemicals.

Storage

Turn the camera off when not in use. Check that the power-on lamp is off before putting the camera away. Remove the battery if the camera will not be used for an extended period. Do not store the camera with naptha or camphor moth balls, or in any of the following locations:

•Next to equipment that produces strong electromagnetic fields, such as televisions or radios

•Exposed to temperatures below –10 °C (14 °F) or above 50 °C (122 °F)

•Poorly ventilated or subject to humidities of over 60 %

To prevent mold or mildew, take the camera out of storage at least once a month. Turn the camera on and release the shutter a few times before putting the camera away again.

CNotes on the Monitor

•The monitor may contain a few pixels that are always lit or that do not light. This is a characteristic common to all TFT LCD displays, and does not indicate a malfunction. Images recorded using the product will not be affected.

•When framing bright subjects, vertical comet-like streaks that whiten toward either end may appear in the display. This phenomenon, known as “smear,” does not appear in the final photograph and does not indicate a malfunction. Some smear may appear in movies.

•Images in the monitor may be difficult to see under bright lighting.

•The monitor is lit by an LED backlight. Should the monitor begin to dim or flicker, contact your Nikon-authorized service representative.

Technical Notes

119