Nikon FAA350NA Overexposure may, Have occurred, Beyond camera’s, Exposure range, BuLb blinks

WWW.LENSINC.NET

Troubleshooting—continued

LCD panel	Viewfinder	Cause	Remedy	Page
HI appears	HI appears	• Overexposure may	• In P mode, use ND filter.	46-51
		have occurred.	• In S mode, select faster	48
			shutter speed.	50
			• In A mode, select smaller
			aperture (larger f-
			number).
			(If the warning indication
			remains after performing
			above remedies in S or A
			mode, use ND filter as
			well.)
Lo appears	Lo appears	• Underexposure may	• In P mode, use flash.	46-51
		have occurred.	• In S mode, select slower	48
			shutter speed.	50
			• In A mode, select larger
			aperture (smaller f-
			number).
			(If the warning indication
			remains after performing
			above remedies in S or A
			mode, use flash as well.)
Electronic	Electronic	• Subject brightness is	• When the subject is bright,	53
analog exposure	analog exposure	beyond camera’s	use ND filter and when the
display blinks	display blinks	exposure range.	subject is dark, use flash.
buLb blinks	buLb blinks	• Shutter speed is set to	• Cancel the buLb by	48, 62
		buLb in S mode.	selecting 30 sec. or faster
			shutter speed, or select M
			mode to perform Long
			Time Exposure.
¡ or ™ blinks	A appears	• Non-CPU lens is	• If non-CPU lens is	32,
		attached, or no lens is	attached, set the	46,
		attached in P or S	exposure mode to A or M.	48-53
		mode.
Shutter speed	25o appears	• Shutter speed faster	• Release the shutter as it	84
indication blinks		than sync speed is	is to take a flash picture.
		selected in S or M	(Shutter speed
		mode.	automatically shifts to
			1/250 sec.)
100

LCD panel	Viewfinder	Cause	Remedy	Page
—	fi blinks	• Flash has fired at full	• Shoot again after	79, 85
	for 3 sec.	output and	confirming focus
	after flash	underexposure may	distance, aperture or
		have occurred.	flash shooting distance
			range.
Err blinks	Err blinks	• Malfunction detected.	• Release shutter again.
			If the warning
			indication remains, or
			this warning appears
			frequently, contact
			authorized Nikon dealer
					Miscellaneous
			or service center.
FuL blinks	FuL blinks	• Shooting data is full in	• Turn the power switch
		F100’s memory.	off once and on again.
			Warning indication
			disappears and
			additional data will not
			be recorded until the
			data in the memory is
			erased.
& blinks	—	• Red-Eye Reduction or	• Use a Speedlight	81
		Red-Eye Reduction	equipped with Red-Eye
		with Slow Sync is set	Reduction function.
		when a Speedlight
		without Red-Eye
		Reduction function is
		attached.
o–– and	o–– and	• Film rewind stops	• Turn the power switch	29, 35
frame counter	frame counter	midway due to low	off, replace batteries
blink	blink	battery power.	with new ones and
			rewind the film again.

In certain cases, due to static electricity or poorly loaded batteries, the F100’s microcomputer may turn the camera off, even with fresh, properly installed batteries. For the same reason, the film may not advance properly. In each of these cases, to resume operation, simply turn the power off, then turn it on again. Or, remove and reinstall the batteries.

101