5. Using On-Screen Display

Note:

•If using the projector continuously for a long period, set Lamp Interval as shown below.

•To use the projector continuously in Dual mode: allow 2 hours per day of non-

usage time per lamp. To do so, select Lamp Interval → Mode → Dual and set Switching Time and Current Time.

•To use the projector continuously in Single mode: use the two lamps (Lamp 1and Lamp 2) alternately in a cycle of 24 hours or less.

To do so, select Lamp Interval → Mode → Single and set Switching Time and Current Time.

Lamp Interval

Lamp Interval is used to setup the interval to switch the lamp when Dual or Single is selected from Lamp Select.

Select from the following:

Mode – ・When Dual is selected for Lamp Select:

The lamp 1 and lamp 2 will be turned off alternately for 2 hours of time difference in the cycle you selected. Set Switching Time.

・When Single is selected for Lamp Select:

The lamp 1 and lamp 2 will be turned off alternately in the cycle you selected. Set Switching Time.

Note:

12[H] and 1 week is only available when lamp select is Single.

Switching Time – Set the time and day for changing the lamp.

Current Time – Set the current time and day.

Note:

•The option Lamp Interval is not available when Lamp 1 or Lamp 2 is selectedfor Lamp Select.

•When using the built-in clock, put the projector in the standby condition and do

not turn off the main power. Also, do not select Power-saving for Standby Mode. Turning off the main power or selecting Power-saving for Standby Mode will stop the built-in clock.

•After setting the Current Time, if the value between Current Time and Switching

Time is less than five (5) minutes, the first lamp switching instance does not take place.

82