Nikon SF-200 specifications Removing attachment

Open the SF-200 (S)’s magazine cover, pull back the feed push-plate to the end of its grove, and hook it in the notch so that it does not spring back to its original position.

Click the double right-arrow button in the attachment utility to move the feed mechanism to where it is fully visible. If you move the feed mechanism too far, click the left-arrow button to move it back. The single-arrow buttons can be used for fine adjustments. Once the feed mechanism is visible, insert the pegs on the attachment into the holes in the feed mechanism.

Feed-mechanism

attachment

Click the OK button in the attachment utility window to return the feed mechanism to its initial position. You are now ready to begin scanning.

4.4 Removing attachment

When scanning slides with flat mounts or slides less than 2 mm thick, you will need to remove the attachment. Use the attachment utility as described above to move the feed mechanism into the magazine, then remove the attachment and click OK to return the feed mechanism to its initial posi- tion.

Caution

Be sure that the attachment is securely in place. If the attachment is loose, slides may not feed properly and damage to the SF-200 (S) could result.

28