Troubleshooting
If the profile was not properly loaded onto the card the ‘Load settings file?’ entry will be greyed out as shown in the following screen capture:
If this happens, please replace the Compactflash card back into the computer. Return to the Control Centre and press the Configure
Repeat steps 10 through 15, taking special care to ensure that the drive letter specified in step 10 is correct. It is advised that you verify your selection in Windows Explorer before going on.
If ever ything was done correctly this time, the entry should be available and you will be able to continue on.
Wireless Setup Guide
Troubleshooting Guide
Windows XP Service Pack 2 or Later
The
Step 1: Ensure settings have been loaded properly.
Sometimes the
If it is still not connecting properly, please check the settings in the camera and compare them to the ones listed in the instructions contained in this document.
Step 2: Use the ConnectionWizard to isolate the problem.
The
To initiate the connection wizard go to the top level of the Wireless LAN menu in the camera, switch OFF the Wireless LAN system and press the button. Open the ITP Control Centre on your computer and use the values provided there to configure the camera via this interface.
Step 2A: Select the wireless network.
Once the connection wizard is started, it will first show you a list of available wireless networks. Select the appropriate network and then press the Enter button to move on to the next step. If the selected network uses encryption,
you may be prompted for additional information.