CONGRATULATIONS!
Thank you for choosing a CM610 or CM630 loudspeaker from Niles. With proper installation and operation, you will enjoy years of
PACKAGE CONTENTS
Each package contains one pair of CM610 or CM630 loudspeakers; 1 pair of Aluminum MicroPerf Grilles; 1 pair of molded plastic grilles that masquerade as a recessed light fixture and 1 pair of cardboard paint mask/hole cutout templates.
INSTALLATION CONSIDERATIONS
We recommend using the following tools and material to install your Niles CM loudspeaker:
•Cordless drill with 1/4 – and
•Stiff wire, fish tape or glow rods for routing cables
•Rubber gloves and protective eyewear
•Keyhole or drywall saw
•Phillips screwdriver set
•Wire stripper
•Stud finder
•Cable ties
•Pencil
Before starting the installation, please observe the following precautions:
•Turn off all system power before making any connections
•Always wear protective eyewear when using tools
•Make sure hands are clean before installation
•Wear gloves when working with fiberglass insulation
RUNNING WIRES IN WALLS OR CEILINGS
When running loudspeaker wire inside walls or ceilings, use special jacketed cable (a minimum of 18 to
SELECTING THE LOCATION FOR YOUR LOUDSPEAKERS
The CM600 series loudspeakers are designed to be installed in any standard ceiling. There are two considerations for placing the loudspeaker; ease of running the cable to the loudspeaker and coverage of the loudspeaker. The best stereo effect will be achieved if both the loudspeakers are at equal distance from the listener and closer together than the listener is from the loudspeakers. Avoid installing the loudspeakers near corners to prevent a “boomy” or diffracted sound. The CM600 series loudspeakers will cover an area of a circle with a
EXISTING CONSTRUCTION INSTALLATION
IMPORTANT: BEFORE YOU CUT INTO ANY WALL, REVIEW THE PRIOR SECTION ON LOUDSPEAKER PLACEMENT WHEN SELECTING THE LOCATION FOR YOUR LOUDSPEAKERS.
1.When determining the location of the loudspeaker cutout, keep in mind that the mounting dogs will extend 3/4” beyond the cutout. Make sure that you do not place the edge of the cutout directly next to a ceiling joist. Locate the joists using a stud sensor or by hand knocking. Use the supplied cutout template (remove the largest perforated circle and use cardboard square with hole as the template) to determine how large of a hole you will need to cut. These templates are packed with your loudspeakers between the styrofoam packing and the ends of the box.
2.Once you have determined a possible position for the cutout, drill a 1/8” pilot hole just barely through the ceiling (1/2” to 5/8” deep in most homes) in the center of your proposed loudspeaker location.
BE VERY CAREFUL NOT TO DRILL THROUGH EXISTING WIRES, PIPES, OR STRUCTURE. IF YOU FEEL ANY EXTRA RESISTANCE AS YOU ARE DRILLING, STOP.