H I G H D E F I N I T I O N S P E A K E R S E L E C T I O N S Y S T E M
3.Make the connections to the HDL-6. The amplifier/speaker connectors on the HDL-6 are removable. If you wish, you may remove these connectors to facilitate installation. (See Figure 3). Strip 3/8" of insulation from the end of each wire. Tightly twist the end of each wire until no frayed ends remain. Insert each wire into the appropriate hole on the spring-loaded connector terminals. Observe proper phasing
— connect the positive terminals on the HDL-6 to the positive terminals on the amplifier and speakers, and the negative terminals on the HDL-6 to the negative terminals on the amplifier and speakers. If the connectors were removed, reinstall them. (See Figure 4).
4.Locate the pre-printed room labels. Affix the appropriate label to the recessed area over each ON/OFF selector button.
Figure 3
Removing the Connectors
Figure 4
Installing the Connectors
