FINISHING THE INSTALLATION
CONNECTING & INSTALLING THE LOUDSPEAKER
1.Please be sure to install the correct loudspeaker in the correct room position. Look on the rear label for “Right” or “Left” designation. Install in the appropriate position as viewed from the listening position facing the video display.
Right
Rear 
Optional
Right Placement
Rear
Left
Left
Figure 5. Two pairs of loudspeakers reproduce Dolby Surround EX® surround sound in a home theater room.
Optional
Placement
2.Remove the magnetic grille starting at a corner and gently pulling the grille outwards as you work around the edges.
3.At each loudspeaker, route the loudspeaker and optional trigger wire through the provided channel to the input connectors, then separate the loudspeaker wire so that at least 2 inches of each conductor are free. Strip away 1/4 inch of insulation from each loudspeaker wire. If you wish to use the 12 volt triggered Dipole/Bipole automated feature, please insert 1/8” (3.5mm) plug above speaker inputs. Refer back to page 5 for details.
4.On each set of loudspeaker connectors, press down the
NOTE: OBSERVE CORRECT POLARITY: POSITIVE (+) GOES TO THE RED POST AND NEGATIVE
(–)GOES TO THE BLACK POST. IF YOU ARE UNSURE OF WIRE POLARITY, SEE THE SECTION, CHECKING LOUDSPEAKER PHASE ON PAGE 9.
5.Connect the other end of each loudspeaker wire to the receiver (or amplifier) in the same way.
6.Check that loudspeaker is level and then tighten the eight large screws using a #2 Phillips bit. This should pull the frame and mounting dog together (sandwiching the drywall) so that the frame is absolutely flush with the wall surface. There should be no gaps between the wall and the frame.
8
