Niles Audio MSU250 INSTALLATION CONSIDERATIONS (CONTINUED) WIRING

INSTALLATION CONSIDERATIONS (CONTINUED)
WIRING
From every IR Sensor location you must “home-run” a CAT-5 cable back to the MSU250.
Home run means that an individual cable is connected between each IR Sensor and the MSU250
(Figure 4).
6
(CONTINUED ON NEXT PAGE)
TECH TIP
WIRE SIZE IS EXPRESSED
BY ITS AWG (AMERICAN
WIRE GAUGE) NUMBER
– THE LOWER THE
NUMBER, THE LARGER THE
AWG, FOR EXAMPLE,
20 AWG IS PHYSICALLY
LARGER THAN 22 AWG.
Remotely Located
IR Sensors
Figure 4:
Home run the sensor cable
from the sensor to the MSU250
Sensors In
NOTE: IMPORTANT – AVOIDING INTERFERENCE AVOID LOCATING ANY OF THE CABLES, SENSORS,
KEYPADS OR THE MAIN SYSTEM UNIT NEAR ANY POTENTIAL SOURCES OF ELECTRO-MAGNETIC
INTERFERENCE (EMI), SUCH AS LIGHT DIMMERS, SPEED CONTROLS FOR CEILING FANS,
ELECTRICAL BALLASTS, TELEVISION SETS, LARGE MOTORS, HEATERS OR AIR CONDITIONERS