INSTALLATION
3.Connect one stripped end of the speaker cable coming from the amplifier to the RS8Si connection cable’s red wire of one cable and the RS8Si connection cable’s yellow wire. To connect the three wires, twist the stripped ends of the wire together and screw down the wire nut on the twisted wires. The material inside the wire nut will protect the stripped ends of the wire. However, if added protection is desired, place a large amount of silicon sealant so the bottom of the wire nut is encased and sealed. Pay attention to the markings on the speaker cable. Each loudspeaker you connect must be connected to the amplifier’s speaker wire in the same way.
4.Repeat step 3 with the RS8Si connection cable’s black wires and the other stripped amplifier speaker cable’s conductor.
5.Connect the opposite end of the speaker cable to the amplifier or receiver. Start by performing step 1 and 2 on the speaker cable near the amplifier. Paying attention to the markings on the speaker cable conductor, attach the same conductor you attached to the red loudspeaker wire to the positive (red) or (+) amplifier output terminal. Attach the other conductor to the amplifier’s negative (black) or
Speaker Phase
Speaker wire has two conductors. One conductor is attached to the negative (black) or
In one-speaker stereo mode
1.Play some music with the amplifier or receiver set to Mono.
2.Stand in the middle of each speaker and three feet away from it. Listen to the richness of the bass and the loudness of the sound.
3.Turn off the amplifier and reverse the connections on one side of the speaker only.
4.Repeat the listening test with the same setting of the volume controls. If the current sound has a richer bass and is slightly louder than the previous sound, the speakers
13