INSTALLATION
Line Level Audio Inputs
Caution! The amplifier must be off whenever you make changes to the input con- nections.
STEP | DESCRIPTION |
1. Correctly label the interconnecting | Use audio patch cables terminated with |
cables coming from each source. | RCA connectors. |
|
|
2. Connect the sources by inserting the | Connect outputs from your source compo- |
RCA connectors into a BusMatrix™ | nents to the input jacks on the amplifier. |
input or dedicated input jack on the | NEVER connect a preamplifier or source |
input (e.g., record inputs) to the | |
NOTE: When you are using two ampli- | inputs. |
| |
fier channels in the "bridged" mode, |
|
assign the audio signal to be ampli- |
|
fied to the EVEN numbered amplifier |
|
channel using the BusMatrix™ Dip |
|
Switches. |
|
|
|
Cascade Audio Outputs
The "Cascade Audio Outputs" enable you to connect additional amplifiers to your preamplifier's output. Connection is accomplished with standard RCA interconnect cables. The outputs are not buffered; to daisy chain more than five Niles amplifiers you will need a Niles
AC Power Plug
STEP | DESCRIPTION |
1. Plug the | If you use a grounded power strip, surge |
power cord into a correctly grounded | protector, or extension cord, verify that the |
120 Volt, | proper ground is maintained |
|
|
CAUTION! DO NOT PLUG THE | 1. The |
POWER CORD INTO A PREAMPLIFI- | 890 watts from an AC wall outlet. This is |
ER'S CONVENIENCE OUTLET. | much more than the typical accessory |
| outlet on a component's rear panel can |
| provide. |
| 2. Use the |
| to switch "ON" the |
| preamplifier is "ON". |
|
|
INSTALLATION
16