Niles Audio SI-1260 manual Setting the Turn-OnMode Switch, The Control Output, Installation

Setting the Turn-On Mode Switch

The SI-1260 has three (3) turn-on modes. Select the desired mode by sliding the mode switch to the proper position. See Installation Considerations on page 14 and Figure 10 for more information about each of the turn-on modes.

Figure 18

Slide the switch with either your fingernail or a 1/8” slotted screwdriver blade.

INSTALLATION

The Control Output Figure 19

As shown in Figure 19, a 3.5 mm female mini- plug output jack on the rear panel of the SI-1260 provides a 12V DC trigger signal. It is suitable for triggering Niles automated switchers, some motorized screens and electric curtain controls and other devices that require a constant 12V DC control voltage for activation.

This voltage is provided only when any of the amplifier channels are active or "ON". When all amplifier channels are "OFF", the 12V signal is "OFF".

Using the 3.5 mm jack.

STEP	DESCRIPTION
1. Check the requirements of the	The control output provides 150 mA of
device you want to control.	current maximum.
2. Connect the 3.5mm jack to the	Niles makes an accessory cable
control output maintaining proper	plug FG00724.
polarity (tip = +)

22