Niles Audio SI-250, SI-2100, SI-2150 manual Plug the male end of the AC power, AC Power Plug

Installation

AC Power Plug

STEP	DESCRIPTION
1. Plug the female IEC socket of the
supplied AC power cord (the supplied	Just like a computer or printer, the
power cord is designed for 120V AC
	Niles System Integration Amplifier®
wall outlets), or use an appropriate	has an AC cord which unplugs
IEC AC power cord to match the
	either at the amp or at the wall for
electrical wall outlet you are using
	your convenience.
(e.g. 240V AC), into the IEC receptacle
on the rear of the amplifier.
2. Plug the male end of the AC power	If you use a grounded power strip,
	surge suppressor or extension
cord into a correctly grounded wall
	cord, verify that proper ground is
outlet.
	maintained.

Caution! Typically a preamp/receiver’s switched outlet is not rated for a power amplifier. The SI- 250, the SI-2100 and the SI-2150 draw 200 watts, 300 watts, and 400 watts maximum from an AC wall outlet respectively. Use a dedicated AC wall outlet along with the amplifier’s auto turn on circuit to ensure adequate power.

16 WWW.NILESAUDIO.COM