Niles Audio SVL-2 manual Operation

S P E A K E R S E L E C T I O N / V O L U M E C O N T R O L S Y S T E M

Operation

The are two ways to use the SVL-2. You may play and adjust the volume of either pair of speakers independently, or both pairs simultaneously.

If you intend to play both pairs simultaneously, and either pair is less than 8 ohms, you will need to become familiar with the operation of the SVL-2's PROTECTION button.

Playing One Pair of Speakers At a Time

1.Make sure the amplifier or receiver power is OFF and set the volume to minimum.

2.Set the SVL-2 volume control for the speaker pair you wish to play to maximum (fully clockwise).

3.Locate the ON/OFF button on the SVL-2 which corre- sponds to the speaker pair you wish to play. Set it to the ON position.

4.Turn on the amplifier or receiver and select as source, such as the tuner or CD player.

5.Slowly turn up the amplifier or receiver volume and set it to a comfortable (not maximum) listening level. Be careful not to overdrive or "clip" your amplifier. If the sound becomes muddy or distorted, you have reached the limit of your amplifier's volume capability and should quickly reduce the volume to avoid damaging your speakers.

"TECH TIP"

If your amplifier or

receiver has "A" and "B" speaker- pair outputs, connect the SVL-2 to the "A" outputs. Do not connect anything to "B". This will prevent the amplifier or receiver from driving an unusually low impedance load.

10