S P E A K E R S E L E C T I O N / V O L U M E C O N T R O L S Y S T E M
6.Using the appropriate volume control on the front of the SVL-2, adjust the volume of the speakers to the desired listen- ing level.
7.You can turn off the speakers by turning the appropriate volume control on the SVL-2 fully counter-clockwise, or by pressing the ON/OFF button.
Playing Two Pairs of Speakers Simultaneously
1.Make sure the amplifier or receiver power is OFF and set the volume to minimum.
2.On the right side of the SVL-2's front panel is a button labeled PROTECTION. This button activates the SVL-2's imped- ance correction circuitry. The circuitry assures that your receiv- er or amplifier will see a safe operating load when playing two pairs of speaker simultaneously. Since most receivers and amplifiers are not rated for use below a 4 ohm load, you will need to activate the PROTECTION button whenever the over- all system impedance might fall below 4 ohms. Use the follow- ing chart as a guide for setting the PROTECTION button.
| When playing the following speakers: | The Protection button should be: |
|
| 1 or 2 pair of 8-ohm speakers | OFF |
| 1 pair of 4-ohm speakers | OFF |
| 2 or more pairs of 4-ohm speakers | ON |
| Any combination of 4 and 8 ohm speakers | ON |
| | |
Set the PROTECTION button to the correct position using the chart shown above.
