Niles Audio SVL-6 manual Constant Protection Switch, Balancing Speaker Volume

S P E A K E R S E L E C T I O N / V O L U M E C O N T R O L S Y S T E M

Constant Protection Switch

The SVL-6 is equipped with a manual override for the protec- tion circuit that enables you to defeat the front panel protec- tion switch and maintain constant impedance protection. This will safeguard your amplifier from being overdriven due to accidental or improper use by anyone unfamiliar with the equipment.

To engage this override, move the rear panel "CONSTANT PROTECTION" switch to the "ON" position. Constant imped- ance protection will be maintained until the switch is turned to "OFF".

Balancing Speaker Volume

The volume control on your receiver or amplifier serves as the "master" volume for all speaker pairs connected.

The volume level of the speakers may vary from room to room. This is caused by several factors. Two lesser factors are the size of the speaker and its efficiency. The largest factor is the physical size of the room.

The SVL-6's volume controls allow you to adjust the volume of each speaker pair individually. You can leave the amplifier or receiver volume set at one position and use the SVL-6 vol- ume controls exclusively.

SPECIFICATIONS

Audio Power

Handling

100watts/channel continuous music power

Frequency Response

+/- 1.2 dB from 20 Hz to 20 kHz

Mounting

Table-Top component

Wiring Requirements

Individual runs of

2-conductor speaker wire. Connectors accommodate wire sizes 14-22 gauge (16 gauge recommended)

Overall Dimensions

17" wide x 2" high x 9-1/4" deep

Weight

8 3/4 lbs.

1

4