
V O L U M E C O N T R O L D I S T R I B U T I O N H U B
V O L U M E C O N T R O L D I S T R I B U T I O N H U B
the screws to the mounting surface. TAKE CARE NOT TO OVERTIGHTEN THE SCREWS, WHICH COULD DAMAGE THE HOUSING.
3.Locate the connector plugs (and remove them if they are plugged in).
4.Strip 1/4" of insulation from the end of each wire. Tightly twist the end of each wire until no frayed ends remain.
5.Use a small flathead screwdriver or your thumbnail to raise the locking tabs, exposing the holes on the removable con- nector plug.
6.Insert each wire into the appropriate hole on the removable connector plug, and snap the locking tab down.
NOTE: Maintain proper phasing. Connect the positive termi- nals on the VCS HUB8 to the positive terminals on the ampli- fier or receiver, and on the volume controls. Connect the neg- ative terminals on the VCS HUB8 to the negative terminals on the amplifier or receiver, and on the volume controls. To help you avoid improper phasing, the connector plug is keyed. Insert the smooth side of the connector plug into the smooth side of the socket. Don’t force the scalloped side of the con- nector plug into the smooth side of the socket.
7.Plug the connectors into the VCS HUB8 as shown. See Figure 4. The single connector plug at lower right is the input from the amplifier or receiver. The other connector plugs are the outputs, each leading to a specific volume control.
SPECIFICATIONS
Mounting
In a
On a wall or other flat surface, secured with drywall screws (not supplied)
Wiring Requirements
Unit Dimensions
6.85" wide x 3" high x 1.3" deep
CONTENTS
VCS HUB8
•VCS HUB8
•
•Removable speaker connector X9
5 | 6 |