Nilfisk-ALTO ALTO Q user manual Installation & Connection, Mains Connection, Audio Connection

13.AC Inlet

After the correct voltage has been set you can connect the AC plug to the unit and in the AC power socket.

14.Input Connectors

Both XLR and 1/4" TRS jack input connectors are supplied in your LTO-Q for maximum flexibility.

15.Output Connector

Both XLR and 1/4" TRS jack output connectors are supplied in your LTO-Q for maximum flexibility.

4. INSTALLATION & CONNECTION

4.1 Mains Connection

A Main AC cable that meets all the international safety regulations is supplied with your LTO-Q. Please make sure of the supply voltage available in your Country before plugging in the power cord into the AC socket.

4.2Audio Connection

Both XLR and 1/4" TRS connectors are available on your LTO-Q. In this way you can interface your LTO-Q in several different ways without experiencing any noise or signal loss. You can use your LTO-Q with single instruments using the mixers main insert or on the complete mix connecting the LTO-Q in between the mixer and the power amp- lifier.

- Wiring Configuration

Either the 1/4" TRS phone jack or the XLR connector can be wired in balanced and unbalanced modes, which will be determined by the actual application status, please wire your system as the following wiring examples:

For 1/4" Phone jack

+		+		+
		-
Tip	Ring	Tip	Ring	Tip
Sleeve		Sleeve		Sleeve
TS Type Unbalanced	TRS Type Balanced		TRS Type Unbalanced

For XLR connector

	Pin2 (+)		Pin2 (+)
		Pin3 (-)
	Pin3 (-)
	(Linked to Pin1 manually, )
Pin1 ( )			Pin1 ( )

XLR Type Unbalanced XLR Type Balanced

- In Line Connection

For these applications the 5-Band Parametric Equalizer provides 1/4" TRS connectors and XLR connectors to easily interface with most any professional audio device. Follow the configuration examples below for your parti- cular connection.

6