Nilfisk-ALTO AMX-140FX user manual 4.8 PAN/BAL Control

In the AMX-140FX model, excluding sending out directly to the external effect or processor equipment, the AUX SEND2 will also be sent to the internal onboard effect module.

4.8 PAN/BAL Control 11

Abbreviation of PANORAMA control for mono channels, for the stereo channels, always says, BALANCE control.

You can adjust the stereo image of the signal via this control. Keep this control in center position and your signal will be positioned in the middle of stage. Turn this control fully counterclockwise and the signal will be present only on the left speaker and vice-versa.

4.9 PEAK LED 12

Inside your AMX-140(FX) the audio signal is monitored in several different stages and then sent to the PEAK LED. When this LED blinks, it warns you that you are reaching signal saturation and possible distortion. The PEAK LED will blink with a level that is 6dB before actual clipping.

4.10 LEVEL Control 13

This control will adjust the overall level of this channel and set the amount of signal sent to the main output.

4.11 MAIN MIX LEVEL Dial 14 21 20

This control sets the amount of signal sent either to the main out socket or to the tape output.

4.12 OUTPUT LEVEL LED Display 15

This stereo 12 segments LED meter will indicate the level of the overall output signal.

- 8 MAX

PHONES /CTRL ROOM

-

8

MAX

2TK IN

2TK TO

CTRL ROOM

2TK TO MIX

TAPE

18

19

OUTPUT LEVEL

4.13 POWER LED	16			-7-4 -2 0 2	4			L
			-10			7
		-30 -20					10
This LED indicates when the power is on in your								CLIP
AMX-140(FX).				PWR	PH			R

15

16

4.14 PHANTOM LED 17

This LED indicates when the phantom power is switched on.

4.15 TAPE Switches
- 2TK TO CTRL ROOM	18

Engaging this button to route the 2 TRACK IN signal into the control room output.

- 2TK TO MIX 19

Engaging this button to route the 2 TRACK IN signal into the main output.

- 8 +15

MAIN MIX LEVEL

14

17

11