Nilfisk-ALTO AMX-140FX user manual DFX Footswitch, Tape OUT

4.23 24 BIT DIGITAL EFFECTS (For AMX-140FX Model)

- PRESETS Control 28

Adjust this knob to select the right effect you wish to perform. There are total 16 options for you: several kinds of reverb, mono and stereo delay, effects with modulation, and versatile two-effect combination.

- VARIATIONS Control 29

Since you have selected the preferable effect, the next step, please go with the fine consideration, there are also total 16 variations for each preset. Each variation may be managed by several different factors.

- MUTE Switch 30

This switch is used to activate/deactivate the effect facility. Sometimes, you can also use the DFX FOOTSWITCH for con- venient operation.

- PEAK LED 31

This LED lights up when the input signal is too strong.

In case of the digital effect module being muted, this LED also lights up.

- DFX FOOTSWITCH 32

This 1/4" phone jack can be used to connect an external foot- switch to turn on/off the onboard effect module.

4.24 2TK IN/OUT Connectors 33

- TAPE IN

Use the tape input if you wish to listen to your mix from a taper recorder or DAT. You can assign the signal coming from the taper recorder either to a pair of studio monitor using the control room assignment on the front panel or you can also send the signal directly to the main mix.

- TAPE OUT

These RCA jacks will route the main mix into a tape recorder.

DSP

FOOTSWITCH

32

16		1	2
15			3
14				4
13				5
12				6
11			7		28
10		9	8
	PRESETS
16		1	2
15			3
14				4
13				5
12				6
11			7		29
10		9	8

VARIATIONS

31

PEAK

30

DFX MUTE

1.VOCAL 1

2.VOCAL 2

3.LARGE HALL

4.SMALL HALL

5.LARGE ROOM

6.SMALL ROOM

7.PLATE

8.TAPE REVERB

9.SPRING REVERB

10.MONO DELAY

11.STEREO DELAY

12.FLANGER

13.CHORUS

14.REV. + DELAY

15.REV. + FLANGER

16.REV. + CHORUS

2-TRACK IN/OUT

L

R

33

TAPE IN TAPE OUT

13