12
english
ATTIX 360-2M
ATTIX 550-2M / ATTIX 560-2MXC
ATTIX 751-2M / ATTIX 761-2MXC
1) Option depending on model
7.2.5 Replacing filter element
(ATTIX 360-2M/550-2M/
751-2M)
1. Open the retaining clamps
and remove the upper section
of the cleaner from the dirt
tank. Lay the upper section of
the cleaner down with the filter
element facing upwards.
2. Turn the filter holder anticlock-
wise (1) and remove it (2).
3. Place the protective filter bag1)
over the filter element (3).
4. Carefully remove the filter ele-
ment and close the protective
filter bag with a knot.
5. Clean the filter seal (4). Check
it for damage and replace it if
necessary.
6. Check the antistatic clamp (5)
for damage and have it re-
placed by Nilfisk-Alto Service
if necessary.
7. Fit a new filter element.
8. Check that the float (6) works
properly. When the filter holder
is turned, the float inside must
move about easily.
9. Fit the filter holder and turn it
clockwise to secure it firmly.
10. Dispose of the used filter ele-
ment in accordance with legal
regulations.
Never use the vacuum cleaner
without a filter.
During the following work, ensure
that dust is not unnecessarily
spread around. Wear a P2 breath-
ing mask.
1) Accessory. Order No. shown in section 9.5.
3
6
1
2
1
2
5
4
7.2.6 Replacing filter element
(ATTIX 560-2MXC/
761-2MXC)
During the following work, ensure
that dust is not unnecessarily
spread around. Wear a P2 breath-
ing mask.
1. Open the retaining clamps
and remove the upper sec-
tion of the cleaner from
the dirt tank. Lay the upper
section of the cleaner down
with the filter element facing
upwards. Do not place the
upper section of the cleaner
on the guard (1) and do not
damage the filter element.
2. Open the bar handle (2) and
remove it.
3. Remove the filter holder (3).
4. Place the protective filter
bag 1) over the filter element.
5. Carefully remove the filter
element and close the pro-
tective filter bag with a knot.
6. Clean the filter seal (4).
Check it for damage and
replace it if necessary.
4
1
3
2