23.AC Inlet
This connector is meant for the connection of the supplied main cord. Do not insert power cord into unit until
voltage has been correctly set. Do not plug power cord intoAC power until voltage has been correctly set.
The fuse-holder above theAC connector on the rear of the chassis has 3 triangular markers(please refer to the above
pictures), with two of these triangles opposing each other,your unit is set to the operating voltage printed next to these
markers.
Tochange, pull fuse-holder out and rotate 180 , then push in again.
THISIS SET FOR
110VAC TO 120V
ACOPERATION
THISIS SET FOR
220VAC TO 240V
ACOPERATION
22. Fuse holder / Voltage electorS
This is a dual voltage unit. Before you attempt to connect and operate the unit, please make sure that your local
voltage matches the voltage on the fuse-holder cover.
Caution: The fuse protecting theAC supplies circuits of this unit. The fuse can only be changed by a qualified
technician, in the event of a fault or changing the supply voltage. If the fuse continues to blow after replacing,
discontinue use of this unit before repaired.
220-240V
110-120V
110-120V
220-240V
3.4 Connectors on The Rear Panel
Pic.5 The Rear Panel of The CLE 2.0
TIP/PIN2TIP/PIN2
SLEEVE/PIN1
RING/PIN3
OPERATINGLEVEL
RING/PIN3
SLEEVE/PIN1
RETURN
SLEEVE/PIN1
RING/PIN3
TIP/PIN2
SEND
TIP/PIN2
RING/PIN3
SLEEVE/PIN1
OPERATINGLEVEL
OUTPUT INPUT SIDECHAIN OUTPUT INPUT SIDECHAIN
4dBu
10dBV
4dBu
10dBV
SLEEVE
TIP TIP
SLEEVE
TIP
SLEEVE
TIP
SLEEVE
CHANNEL1CHANNEL2
ACINPUT
95-120V/210-240V 60-50Hz
RatedPowerConsumption14W
FUSE:
210-240V:T200mAL250VAC
95-120V:400mA250VAC
REPLACEFUSEWITH
CORRECTTYPEONLY
RETURN SEND
21
3
21
3
22
23 24
25 26 27 28
110-120V
220-240V
These connectors are used to input the signal source. Youcan input the signal via the balanced 1/4" TRS phone
jack or XLR connector.
24.Audio In
9
25.Audio Out
These connectors are used to output the signal. Youcan output the signal via the balanced 1/4" TRS phone jack or
XLR connector.
This control is used to adapt this unit to either the -10dBV home recording operating level or the +4dBu professional
studio operating level.
The Input / Output Level Meter (18) is referenced automatically to the selected level, i.e. an optimum operating range
of the meter will always be ensured.
26. Operating Level Control