Nilfisk-ALTO DJM-3 user manual AC Inlet and Fuse Holder, Uk/Aust

3.3.The Rear Panel

UK/AUST	USA / Canada
210-240V 50Hz	100-120V	60Hz
Fuse:T200mAL	Fuse:T400mAL
		CAUTION
AC INPUT		RISK OF ELECTRIC SHOCK		MODEL
		DO NOT OPEN
EUROPE		WARNING: SHOCK HAZARD - DO NOT OPEN
210-240V	50Hz	AVIS: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
Fuse:T200mAL
RATED POWER CONSUMPTION: 12W
Apparaten skall anslutas till
Jordat uttag nar den ansluts			MAIN	TAPE
Till ett natverk
fuse 250V a with only Use		POWER
		ON
		OFF	MAIN OUT

SERIAL

		GND	GND
SEND	RETURN
FROM PFL	TO MAIN	LINE PHONO	LINE PHONO
		L
		R
EFFECTS		INPUT 2	INPUT 1
		PHONO	PHONO
		LINE	LINE

27 28 29 30 31 32

3.3.1 AC Inlet and Fuse Holder 27

The fuse holder position (please follow the triangle that indicated the voltage accepted by the unit) can be changed only by a qualified Engineer. Please check the Voltage accepted by the unit and the Voltage available from your AC sockets before connecting the unit to the Mains.

3.3.2 POWER Switch 28

This switch turns the Mixer ON and OFF.

3.3.3 MAIN OUT 29

Both MAIN output and TAPE output are RCA types connectors. Yes the same largely used in hi-fi and are low impedance. Through the MAIN output you can connect your DJM 3 to an amplifier. Through the TAPE output you can connect your DJM 3 to a tape recorder.

3.3.4 EFFECTS send and return 30

You can send the PFL (pre fader level) signal through the SEND sockets to a signal processor such as reverb, equaliser, etc. Then from the same effect unit you bring the signal back into the DJM 3 via the RETURN sockets and the audio signal is routed into the MAIN output.

3.3.5 INPUT 31

-PHONO input: Both Channels feature PHONO inputs including RIIA preamplifier for turntable. PIN (RCA) jacks shall be used to connect the turntable.

-LINE input: Through these RCA type sockets you can connect a CD player, an MD player or any other high level device such as Tape Recorder, DAT, etc,

Important Notice: If you wish to connect LINE level devices into the LINE/PHONO input, make sure that the LINE/ PHONO switch is on LINE position otherwise the sensitive RIAA preamplifier built-in in the Phono input will be overloaded and will produce distortion.

3.3.6 GND screw 32

This grounding connection is provided for your turntables.

10