4.3 Water connection | An ordinary 1/2" garden hose of |
| min. 10 m and max. 25 m will |
| be suitable. |
| NOTE: Connection to the public |
| mains according to regulations. |
|
|
|
|
4.4 Start and stop of the | The spray lance is affected |
machine | by a thrust during operation |
| - therefore always hold it fi rmly |
| with both hands. IMPORTANT: |
| Point the nozzle at the |
| ground. |
1. Check that the machine is in uprigth position.
NOTE: Do not place the ma- chine in high grass!
2. Release the trigger lock (7a).
3. Activate the trigger of the spray gun and let the water run until all air has escaped from the water hose.
4. Press the Start/stop switch "I" (1).
5. Activate the trigger of the spray gun.
Always adjust the distance and thus the pressure of the nozzle to the surface, which is to be cleaned.
IMPORTANT! Only use wa- ter without any impurities. If there is a risk of running sands in the inlet water (i.e. from your own well), an additional
filter (106411231) should be mounted.
1.Let the water run through the water hose before connecting it to the machine to prevent sand and dirt from penetrat- ing the machine.
Note: Check that the fi lter is fi tted in the water inlet pipe and that it is not clogged up.
2.Connect the water hose to the water supply by means of the quick connector (inlet water, max. pressure: 10 bar, max. temperature: 40°C).
3.Turn on the water.
Do not cover the machine during operation or use it in a room without adequate ventila- tion !
Note: If the ma- chine is left or not used for 5 min-
utes, it must be switched off on the start/stop switch "O" (1):
1.Press the start/stop switch "O".
2.Disconnect the electrical plug from the socket.
3.Shut off the water supply and activate the trigger to relieve the machine of pressure.
4.Lock the spray gun (7a).
When releasing the trigger of the spray gun, the machine automatically stops. The ma- chine will start again when you
9
