Then put the
If your ECU has no daughter board then the USB connector board may face upwards. If you are using a daughter board then ensure that the USB adaptor board faces downwards and does not touch any other components.
Notes:
A31 RB20/ S13 CA18: It may be necessary to use longer screws to hold the original potentiometer bracket.
U13 KA24E/EK10 MA09: The bracket has a single screw. You will need to fabricate a custom bracket using two screw holes to hold the USB adaptor
HR31 RB20: We have found that there is no room for the USB connector. You may have to relocate this bracket by drilling and tapping new holes in a different location if you wish to have this fitted permanently
Ensure your USB socket is installed correctly and pressed against the ECU casing. This provides a ground contact point for the USB shield to the board, to absorb electrical noise and prevent unwanted USB disconnects during operation.
NIStune Type 1 Hardware Installation | Page 24 of 24 |