EPSON Stylus Pro and Pro XL
1. Remove the output tray from the top of the paper tray.
rear edge guide
left edge guide
2.Slide the left edge guide inside the paper tray to the left as far as it will go.
3.Flip up the rear edge guide and slide it toward you as far as it will go.
4.Fan a stack of paper; then tap it on a flat surface to even the edges.
5.Load the stack of paper, printable side down, so that its right edge rests against the right side of the paper tray. Slide the stack into the tray until you feel some resistance. Then slide the left edge guide against the left edge of the paper as shown below.
You can load up to 100 sheets of plain bond paper, but do not load paper above the arrow mark on the left edge guide.
6. Slide the rear edge guide against the rear edge of the paper.
Loading Oversized Paper
If you are loading paper that is larger than the paper tray, you need to pull out the paper tray extension. Follow these steps:
1.Remove the output tray and remove any paper in the paper tray.
2.The paper tray extension acts as the rear edge guide, so make sure the
paper tray extension
3.Gently pull the extension out using both
4.Load the stack of paper in the tray and then slide in the extension until it meets the edge of the paper stack.
5.Replace the output tray and fold out its extension.
7. Place the output tray on top of the paper tray.
Using Special Papers and Other Media
This section explains how to use and load special coated paper, glossy paper, transparencies, and envelopes in the printer. When using these special types of media, keep the following in mind:
❏Use special coated paper and glossy papers within one year of purchase. Use transparencies within six months.
❏Do not touch the printable surface of the paper. The moisture and oils on your hands can reduce print quality. Hold sheets by their edges.
EPSON Stylus Pro and Pro | 8/1/95 | Ink Jet Printers |