
3.Insert the card into the microSD card slot with the contact surface facing down, and press it until it locks into place.
4.Replace the battery.
5.Replace the back cover.
Remove the microSD card
1.Remove the back cover of the device.
2.Remove the battery.
3.Press the microSD card slightly to release the lock, and pull the card out.
Charge the battery
Your battery has been precharged, but the charging levels may vary.
1.Connect the charger to a wall outlet.
2.Connect the charger to the device.
3.When the battery is fully charged, disconnect the charger from the device, then from the wall outlet.
You also may charge the
Get started
battery with a USB cable with power from a computer.
1.Connect the USB cable to the USB port of a computer and to your device.
2.When the battery is fully charged, disconnect the USB cable.
If the battery is completely discharged, it may take several minutes before the charging indicator appears on the display or before any calls can be made.
The charging time depends on the charger used. Charging a
Antenna
Your device may have internal and external antennas. As with any radio transmitting device, avoid touching the antenna area unnecessarily while the antenna is transmitting or receiving. Contact with such an antenna affects the communication quality and may cause the device to operate at a higher power level than otherwise needed and may reduce the battery life.
The figure shows the antenna area marked in grey.
Strap
1. Remove the back cover.
© 2009 Nokia. All rights reserved. | 13 |