I n s t a l l a t i o n

Unplug the appropriate cables from the car radio, and insert the ISO cable plug instead. Connect the open ends of the cables to the car radio speakers.

Connect one of the wires labelled Mute 1, Mute 2, or Mute 3 on the car radio to the ISO cable. Leave the other mute wires connected as they are.

Insert the power cable plug of the ISO cable to the respective connector on the hands-free unit.

Check the +12-V power pin and the ignition pin on the car radio and the respective pins of the ISO cable. If necessary, swap the pins on the fuses of the ISO cable. Plug the ISO cable to the two open ISO connectors.

2.Plug the ISO cable to the respective connector on the hands-free unit.

After you have connected the ISO cable, connect the external input device CU-11 and the microphone MP-2 to the respective connectors on the hands-free unit.

To charge a compatible Nokia mobile phone through the car kit, connect one end of the supplied charging cable CA-134 to the hands-free unit and the other end to the 2.0-mm (0.08 inch) charging connector of the phone.

Use the car kit amplifier for calls and the car radio amplifier for music

In this setup, the car radio is muted when you make or receive a call.

The amplifier and equaliser of your car radio are used for music played on a connected device that supports the A2DP profile. The built-in amplifier of the car kit is used for calls.

Music played on A2DP devices and Nokia Maps navigation prompts played on some Nokia device models are directed to the AUX input of the car radio. To hear the music and prompts, select AUX input on your car radio as the audio source. If the car radio does not have an AUX

20

Page 20
Image 20
Nokia CK-100 manual Installation