Packet data access points
Select Menu > Control panel > Settings and
Connection > Destinations > Access point, and follow
the instructions on the display. Or, open one of the access
point groups, select an access point marked with , and
select Edit.
Use the instructions provided by your service provider to
edit the following:
•Access point name — The access point name is
provided by your service provider.
•User name — The user name may be needed to make
a data connection, and is usually provided by your
service provider.
•Prompt password — If you want to set the device to
ask for a password every time you log in to a server, or
if you do not want to save your password in the device,
select Yes.
•Password — A password may be needed to make a
data connection and is usually provided by your service
provider.
•Authentication — Select Secure to always send your
password encrypted or Normal to send your pa ssword
encrypted when possible.
•Homepage — Depending on the access point type you
are setting up, enter the web address or the address of
the multimedia message centre.
•Use access point — Select After confirmation to set
the device to ask for confirmation before the
connection using this access point is created, or
Automatically to set the device to connect to the
destination using this access point automatically.
Select Options > Advanced settings and from the
following:
•Network type — Select the internet protocol type to
transfer data to and from your device. The other
settings depend on the selected network type.
•Phone IP address (for IPv4 only) — Enter the IP address
of your device.
•DNS addresses — Enter the IP addresses of the primary
and secondary DNS servers, if required by your service
provider. To obtain these addresses, contact your
internet service provider.
•Proxy server address — Enter the address of the proxy
server.
•Proxy port number — Enter the port number of the
proxy server.
WLAN internet access points
Select Menu > Control panel > Settings and
Connection > Destinations > Access point, and follow
the instructions on the display. Or, open one of the access
point groups, select an access point marked with , and
select Edit.
Use the instructions provided by your service provider to
edit the following:
•WLAN network name — Select Enter manually or
Search for networks. If you select an existing network,
WLAN network mode and WLAN security mode are
determined by the settings of its access point device.
•Network status — Define whether the network name
is displayed.
•WLAN network mode — Select Ad-hoc to create an
ad hoc network, and to allow devices to send and
receive data directly; a WLAN access point device is not
needed. In an ad hoc network, all devices must use the
same WLAN network name.
149
Settings