8.Remove the elastic band holding the Upright Wire Harness (75). Insert the Upright Wire Harness (75) through a Handrail Spacer (95). Press the Handrail Spacer into the top of the Right Upright (74). Press a Handrail Spacer into the Left Upright (73).
Have two people hold the console assembly near the Left Upright (73) and the Right Upright (74). Connect the Upright Wire Harness (75) to the console wire. Make sure to connect the connectors properly (see the inset drawing); the connectors should slide together easily and snap into place. If the connectors do not slide to- gether easily and snap into place, turn one connector and try again to connect them. IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.
Insert the Upright Wire Harness (75) and the console wire into the Right Upright (74). Next, insert the brackets on the console assembly into the Right Upright and the Left Upright (73). Be careful not to pinch the wires.
9.Finger tighten three Handrail Bolts (64), with three Handrail Star Washers (90), into the Right Upright (74) and console assembly. Repeat with the Left Upright (73).
After all six Handrail Bolts have been started, tighten the four front Handrail Bolts first before the other two Bolts.
8 |
|
| Console |
| Assembly |
73 | Console Wire |
| |
| 75 |
| 95 |
| 74 |
| 75 |
9 |
|
Console 
Assembly
73 |
| 64 |
|
| |
|
| 90 |
64 | 90 | 74 |
10.Press the Latch Sleeve (96) into the Left Upright (73). If necessary, use a rubber mallet to fully insert the Sleeve.
Remove the knob from the pin. Make sure that the collar and the spring are on the pin. Next, insert the pin into the Latch Sleeve (96) and the Left Upright (73), and tighten the knob back onto the pin.
10 |
|
Knob |
|
| Collar |
96 | Pin |
Spring |
|
73 |
|
9
