NordicTrack 0603.0 user manual Assembly

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor- mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrench and your own phillips screwdriver .

For help identifying assembly hardware, see the drawings below. Note: If a part is not found in the part bags, check to see if the part has been preattached. To avoid damaging plastic parts, do not use power tools for assembly.

		1” Tek Screw (82)–4		3/4” Screw (79)–2
Nut (38)–2	Upright Star		Handrail Star	Washer (78)–6	Base Pad Spacer
	Washer (71)–6		Washer (90)–6
					(77)–4
Upright Bolt	(72)–6	Handrail Bolt (64)–6		Wheel Bolt (85)–2

1.Identify the Left and Right Uprights (73, 74). The Left Upright has two large holes in the indicated locations.

Set the Right Upright (74) near the Frame (48) as shown. Insert the Upright Wire Harness (75) into the lower end of the Right Upright and out of the top.

Place an elastic band around the Upright Wire Harness (75) and the Right Upright (74) to keep the Upright Wire Harness from falling into the Right Upright. Leave the elastic band on until step 6.

1
48	75		74	Small
				Holes
	Band
Large Hole		73		Large Hole

6