ASSEMBLY
•Assembly requires two persons.
•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps.
•The underside of the walking belt is coated with
•To identify small parts, see page 6.
•Assembly requires the following tools:
the included hex keys one adjustable wrench one Phillips screwdriver scissors needlenose pliers
To avoid damaging parts, do not use power tools.
1. Make sure that the power cord is unplugged. |
With the help of a second person, tip the tread- |
mill onto its right side. |
Pull the Upright Wire (70) and the Base Ground |
Wire (92) through the indicated hole in the Base |
(80). |
1 77 1
A 
Hole 
9270
Remove and discard the indicated screw (A) in |
the Base (80). Attach the Base Ground Wire (92) |
to the Base with a #8 x 1/2" Ground Screw (1). |
Press a Base Cap (77) into the Base (80). Make |
80
67
sure that the Grommet (67) is pressed into the |
square hole in the Base. |
See the inset drawing. Cut the plastic tie near |
the Upright Wire (70). Be careful not to dam- |
age the Upright Wire. |
2. Attach a Wheel (81) to the Base (80) with a 3/8" |
x 2 1/2" Bolt (2) and a 3/8" Nut (3). Do not over- |
tighten the Nut; the Wheel must turn freely. |
Tie
Cut
70 
2
2
80
81 
3
7
