Assembly
Make Things Easier for Yourself!
Everything in this manual is designed to ensure that the weight rack can be assembled success- fully by anyone. However, it is important to real- ize that the versatile weight rack has many parts and that the assembly process will take time.
Most people find that by setting aside plenty of time, assembly will go smoothly.
Before beginning assembly, carefully read the following information and instructions:
¥Assembly requires two people.
¥Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
¥Tighten all parts as you assemble them, unless instructed to do otherwise.
¥As you assemble the weight rack, make sure all parts are oriented as shown in the drawings.
¥For help identifying small parts, use the PART IDENTIFICATION CHART on page 5.
The following tools (not included) are required for assembly:
¥ Two adjustable wrenches
¥ One rubber mallet
¥ One standard screwdriver
¥ One Phillips screwdriver
¥Lubricant, such as grease or petroleum jelly, and soapy water.
Assembly will be more convenient if you have a socket set, a set of
1.Press 60mm Square Outer Caps (27) onto the ends of the Right and Left Bases (1, 3).
Attach the Right and Left Bases (1, 3) to the Center Base (2) using four M10 x 78mm Bolts (31) and four M10 Nylon Locknuts (29). Do not tighten the
Nylon Locknuts yet.
2.Identify the two Rear Uprights (8), which are slightly shorter than the Front Uprights (not shown).
Attach the Rear Uprights (8) to the Left and Right Bases (1, 3) using four M10 x 78mm Bolts (31) and four M10 Nylon Locknuts (29). Do not tighten the
Nylon Locknuts yet. Make sure the Uprights are oriented exactly as shown, with the adjustment holes on the indicated side near the bottom.
Press a 60mm Square Outer Cap (27) onto the end of the Weight Guide Base (4).
Orient the Foot Plate (5) and the Weight Guide Base (4) as shown. Attach the Foot Plate and the Weight Guide Base to the Center Base (2) using two M10 x 78mm Bolts (31) and two M10 Nylon Locknuts (29). Do not tighten the Nylon Locknuts yet.
1 |
| 27 |
|
|
|
| |
|
| 29 |
|
| 31 | 2 | 27 |
| 29 | ||
| 1 | ||
|
|
| |
| 27 | 31 |
|
|
|
| |
| 27 | 3 |
|
2 | Adjustment |
| |
|
| Holes |
|
| 8 | 8 |
|
|
|
| |
| 29 |
|
|
| 31 | 27 | |
| 4 |
| |
| 2 |
| |
| 29 |
| |
| 1 |
|
|
|
| 29 |
|
| 31 | 5 |
|
|
| 3 |
|
6
