NordicTrack NTEL05900 user manual Locknut the Incline Bracket must pivot easily

3.Slide an M8 Split Washer (58) and an M8 Washer (33) onto an Incline Axle Screw (30). Tighten the Incline Axle Screw into one end of the Incline Axle (29). Next, apply a small amount of the included grease to the Incline Axle.

Align the indicated tubes on the Incline Frame (5) with the tubes on the Base (1). Make sure that the Incline

Frame is turned so the V-shaped grooves are on top. Insert the Incline Axle (29) through the Incline Frame and the Base. Note: It may be helpful to tap the Incline Axle with a rubber mallet to insert it.

Slide an M8 Split Washer (58) and an M8 Washer (33) onto the other Incline Axle Screw (30). Tighten the Incline Axle Screw into the open end of the Incline Axle (29).

4.Attach the Incline Bracket (24) to the lower end of the Upright (2) with the M10 x 85mm Bolt (25) and an M10 Nylon Locknut (26). Do not overtighten the Nylon

Locknut; the Incline Bracket must pivot easily.

5.The Console (87) requires two “AA” batteries (not included). Alkaline batteries are recommended. To install batteries, turn the Console face down and remove the Battery Cover (97), as shown in the inset drawing. Next, insert two batteries into the Console.

Make sure that the negative ends of the batteries (marked “—”) are touching the springs in the Console. Then, reattach the Battery Cover.

Carefully feed the Resistance Cable (57) down through the Upright (2) until the end of the Resistance Cable extends from the bottom of the Upright. Next, connect the console wire to the Extension Wire (51).

Attach the Console (87) to the Upright (2) with the four Console Screws (35) and the four Console Washers

(98)packaged with the Console. Be careful to avoid pinching the wires.

Snap the bookrack onto the Console (87) where shown.

6

3
				V-shaped Groove
				5
				58
				33
				30
Grease		29		Tubes
58	33
30			1
				Tubes
4
				2
		24	26
	25
5	87
97				Bookrack
Console
Wire
51			57
98			2	97
				87
35	35