NordicTrack NTHK99901 user manual HD1 IFIT2 HD2

4.Set the Console (99) and the Handrail (27) on the floor.

Locate the Handrail Wire Harness (30) in the Handrail (27). While a second person holds the Console (99), con- nect the 8-pin wire of the Handrail Wire Harness to the HD2 connector on the back of the Console. Next, con- nect the 4-pin wire to the IFIT2 connector, and the 3-pin wire to the HD1 connector in the location shown.

5.Attach the Console (99) to the Handrail (27) with the four Small Screws (6). Make sure that the Handrail Wire

Harness (not shown) is not pinched between the Console and the Handrail.

6.Place a Handrail Cover (53) on each Upright (23). Make sure that the Handrail Covers are turned as shown in the inset drawing.

Have a second person hold the Handrail (27) in the posi- tion shown. Connect the Handrail Wire Harness (30) to the Upright Wire Harness (100). Insert both Wire Harnesses into the right Upright (23).

Hold a Metal Spacer (114) inside the right Upright (23) and align it with the first hole in the Upright. Insert a Handrail Bolt (25) with a Handrail Star Washer (26) through the Upright and the Metal Spacer. Hold the Handrail (27) above the Handrail Covers (53) and finger tighten the Handrail Bolt into the Handrail. Repeat this procedure on the left side. Then, tighten the two remain- ing Handrail Bolts with Handrail Star Washers into the Handrail. Be careful not to pinch the wires.

Tighten all of the bolts used in steps 3 and 6. Press the Large Endcaps (86) into the Uprights (23).

4
	HD1
	IFIT2
HD2
99	30
27
5	6
99
		6
		27
6
6
86			27
114
53
26
25	30	114	86
23
			53
	100		26
27
	23
53			25
23

7.Make sure that all parts are tightened before you use the TREKKER. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 22). To protect the floor or carpet from damage, cover the floor under the TREKKER.

7