2.With the help of a second person, carefully tip the Frame (55) and the Uprights (85) down to the position shown.
Make sure that the Base Extension (90) remains in the Uprights.
Carefully slide the Base Cover (92) onto the bottom of the Uprights (85). Attach the Base Cover with four 3/4” Tek Screws (44); start all four Tek Screws before tighten- ing them. Be careful not to overtighten the Tek Screws.
3.Attach the Base Extension (90) with four Extension Screws (87); start all four Extension Screws before tightening them.
Attach the two Thin Base Pads (83) to the base of the Uprights (85) in the locations shown with two 1” Tek Screws (82).
Note: Replacement Base Pads may be included. Use the Base Pads to replace any that becomes worn.
With the help of a second person, carefully tip the Uprights (85) back to the vertical position.
4.See drawing 4a. Look into the openings in the ends of the Shock (86), and make sure that the ends of the metal clips are centered as shown. If necessary, rotate the metal clips slightly. Twist the ends of the Shock, if necessary, to align the openings with the brackets on the Frame (55) and the base of the Uprights (85).
While the other person holds the Frame (55), press the smaller end of the Shock (86) onto the bracket in the cen- ter of the Uprights (85). See drawing 4b. It may be helpful to use a flat head screwdriver to lift each metal clip slightly. Do not remove the metal clips. Make sure to orient the Shock as shown. Press the other end of the Shock onto the bracket in the center of the Frame. Note: It may be necessary to tip the Frame forward or back to at- tach the Shock. Do not tip the Frame forward past the vertical position.
7
2 | 55 |
| 92 |
| 44 | ||
|
|
| |
|
| 85 | 90 |
|
|
| |
3 |
|
|
|
|
|
| 83 |
|
|
| 82 |
|
|
| 87 |
|
| 85 |
|
|
| 87 |
|
| 83 | 90 |
|
| 82 |
| |
4 |
| 4a | Metal Clip |
| 55 | Opening |
|
| |
| 86 | 86 |
|
| |
85 |
| 4b Metal Clip |
86
