2.Attach the four Base Pads (81) (only three are shown) to the base of the Uprights (85) with four 1” Tek Screws (82) and four Plastic Spacers (101). Note: One replacement Base Pad may be included. Use the Base Pad to replace any Base Pad that becomes worn.
With the help of a second person, carefully tip the tread- mill down so the four Base Pads (81) are resting on the floor and the Uprights (85) are in a vertical position.
3.Remove the band securing the Upright Wire Harness (73) to the right Upright (85). Have a second person hold the console assembly near the right Upright.
Connect the Upright Wire Harness (73) to the wires ex- tending from the console assembly. Make sure to con- nect the connectors properly (see the inset drawing). The connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED
PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Insert the connec- tors into the right Upright (85).
4.Remove the band securing the TV Cable (115) to the left Upright (85). Connect the TV Cable to the cable extend- ing from the console assembly. Then, insert the TV Cable into the left Upright.
2 | 101 |
| |
| 81 |
| 82 |
| 101 |
| 85 |
| 55 |
| 101 |
| 81 |
| 82 |
3 |
|
| Console |
| Assembly |
| 73 |
| 85 |
| 73 |
4 | Console |
| |
| Assembly |
| 115 |
| 85 |
8
