NordicTrack NTL14940 user manual Extension Legs 102 remain in the Uprights

Models: NTL14940

1 34
Download 34 pages 55.07 Kb
Page 7
Image 7

4.With the help of a second person, carefully tip the Uprights (69) down as shown. Make sure that the

Extension Legs (102) remain in the Uprights.

Attach each Extension Leg (102) with two 1” Screws

(148)and a Base Pad (99) as shown. Note: Attach the lower Screw (without the Base Pad) first.

With the help of a second person, carefully tip the Uprights (69) back to the vertical position.

Note: A replacement Base Pad (99) may be included. Use the Base Pad to replace any Base Pad that becomes worn.

5.Insert a Handrail (66) into each side of the console as- sembly.Note: It may be helpful to twist the Handrail as you insert it.

Cut the tie securing the Upright Wire Harness (98). Have a second person hold the console assembly near the Uprights (69). Connect the Upright Wire Harness to the wires extending from the Console Base (81). The connec- tors should slide together easily and snap into place. If they do not, turn one connector and try again. Insert the connectors and the Upright Wire Harness down into the right Upright, and then set the console assembly on the Uprights. Be careful not to pinch the wires.

6.Insert two Handrail Bolts (78) with 5/16” Star Washers (77) into the right Upright (69) and the right Handrail (66)

Be careful not to damage the Upright Wire Harness (not shown). Next, lift the right Handrail slightly and align the Bolts with the holes in the Handrail. (Note: If neces- sary, twist the Handrail to align the holes in the Handrail with the Bolts). Thread the Bolts into the Handrail. Do not tighten the Bolts yet.

Attach the left Handrail (not shown) in the same way. Then, tighten all Handrail Bolts (78). Note: There are no wires on the left side.

7.Attach the Upper Handrail (151) to the Uprights (69) with two 3” Bolts (150) and two Handrail Washers (149) as shown. Firmly tighten the Bolts.

8.Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 28). To protect the floor or car- pet from damage, place a mat under the treadmill.

4

 

 

 

69

 

 

 

 

 

 

99

102

99

 

102

 

148

 

 

 

148

 

 

 

5

 

 

81

 

 

 

 

 

98

 

 

 

 

69

 

66

 

Console Assembly

 

 

 

6

 

 

 

 

 

 

69

 

66

 

77

 

 

 

 

 

 

78

7

151

 

 

 

 

 

 

 

 

69

 

150

149

 

 

 

150

7

Page 7
Image 7
NordicTrack NTL14940 user manual Extension Legs 102 remain in the Uprights