8.Set the console assembly on the Uprights (85). Make sure that no wires are pinched. Finger tighten a Console Bolt (72) with a Star Washer (67) into the lower hole in each Upright (only one side is shown).
Next, finger tighten a Short Console Bolt (112) with a Star Washer (67) into the upper hole in each Upright (85) (only one side is shown). Be careful not to drop the Short Console Bolts into the Uprights. Firmly tighten the two Console Bolts (72) and the two Short Console Bolts.
Insert an Upright Endcap (71) into the top of each Upright
(85)(only one side is shown). Note: Insert the end of the Upright Endcap indicated by the arrow first; use a rubber mallet if necessary.
9.Slide the two Upright Covers (75) onto the ends of the Handrails (68, 70). Align the holes in the lower ends of the Handrails with the holes in the Uprights (85). Do not drop the Handrails into the Uprights. Do not cut the indicated tie.
Loosely thread four Handrail Bolts (66) with four Star Washers (67) into the Handrails (68, 70) and the Uprights (85). Firmly tighten the four Handrail Bolts.
10.Press the right Upright Cover (75) onto the right Upright (85). Attach the Upright Cover with a 3/4” Screw (7).
Repeat this step on the other side (not shown).
8 |
|
|
| |
71 |
|
|
| |
85 |
|
|
| |
67 |
|
|
| |
112 |
|
|
| |
67 |
|
| Console | |
|
|
| ||
72 |
|
| Assembly | |
|
|
| ||
9 |
|
|
| |
68 |
|
|
| |
75 |
|
|
| |
|
| 70 |
| |
67 |
|
| Do | |
66 | 85 | 75 | ||
Not | ||||
|
|
| ||
|
|
| Cut | |
|
|
| 85 | |
|
|
| 67 | |
|
| 66 |
| |
10 |
|
|
|
85 
75
7 
9
