4. Cut the plastic tie holding the Upright Wire Harness (119) | 4 |
| |
in the right Upright (99). Have a second person hold the | 56 | ||
| |||
Handrails (83) near the Uprights. Connect the Upright |
|
| |
Wire Harness to the wires extending from the Console |
| 119 | |
Base (56). The connectors should slide together eas- |
| ||
ily and snap into place. If they do not, turn one con- |
|
| |
nector and try again. Then, insert the connectors and |
|
| |
the Upright Wire Harness into the hole in the right |
|
| |
Upright. Set the Handrails on the Uprights, being careful |
| 99 | |
not to pinch the wires. | 83 |
| |
|
| ||
5. Insert two Handrail Bolts (104) with Handrail Spacers | 5 |
| |
(106) into the right Upright (99) and the right Handrail |
| ||
|
| ||
(83). Be careful not to pinch the wires. Make sure that |
|
| |
the Handrail Spacers are flush against the right Upright, |
| 99 | |
with the thick sides facing the center of the treadmill, as |
| ||
| 106 | ||
shown in the inset drawing. Next, lift the right Handrail |
| ||
(83) slightly and align the Bolts with the holes in the | 83 |
| |
Handrail. Thread the Bolts into the Handrail. Do not |
| ||
| Thick | ||
tighten the Bolts yet. |
| ||
| Side | ||
|
| ||
Attach the left Handrail (not shown) in the same way. | 106 | 104 | |
| |||
Then, tighten all four Handrail Bolts (104). |
|
|
6.Make sure that all parts are properly tightened before you use the treadmill. Place a mat beneath the treadmill to protect the floor. For your benefit, familiarize yourself with the information on pages 28 to 30.
7
