NordicTrack NTTL11990 manual Assembly, Your own phillips screwdriver

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench

and your own phillips screwdriver .

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

1. With the help of a second person, carefully raise the	1
treadmill to the upright position.
If there are two Screws (80) in each Extension Leg
(102), remove them. These Screws will be used in as-
sembly step 2.
While a second person tips the treadmill to one side
and holds it, insert one of the Extension Legs (102) into
the treadmill as shown. Make sure that the Extension
Leg is turned so the Base Pad (99) is on the bottom.
Next, tip the treadmill to the other side and insert the		102
		80
other Extension Leg (not shown) in the same way. Lower
the side of the treadmill so that both Extension Legs		99
(102) are resting flat on the floor.
2. With the help of a second person, carefully lower the	2
treadmill frame and then tip the Uprights (69) down as
shown. Make sure that the Extension Legs (102) re-
main in the Uprights.
Attach each Extension Leg (102) with two Screws (80) as		99
shown.		Frame
With the help of a second person, carefully tip the		69
Uprights (69) back to the vertical position.	69
		80
		102
	99	80
		102
3. Place one of the Handrail Spacers (65) on the right	3
Upright (69) as shown. Pull the Upright Wire Harness
		81
(98) up through the Handrail Spacer. Place the other
Handrail Spacer on the left Upright (not shown).		66
Have a second person hold the Handrails (66) near the		69
Uprights (69) as shown. Connect the Upright Wire		65
Harness (98) to the wires extending from the right		98
Handrail. Insert the Wires under the Console Base (81).		69
		65

6