NordicTrack NTTL39910 user manual HOW to Move the Treadmill

4. Refer to step 1. While a second person holds the	4
Uprights (95, 97), remove the two Upright Bolts (96).
Slide the Uprights (95, 97) fully onto the brackets on the	99
Frame (not shown). Be careful to avoid pinching your
hands or the Wire Harness (not shown). Attach each	91
Upright with four Upright Bolts (96) as shown. Firmly		91
tighten all eight Upright Bolts.	97
		95
Firmly tighten the four Handrail Bolts (99).		96
		96
		96
5. Plug the indicated end of the Power Cord (48) fully into	5
the treadmill as shown.
		48

6. When the treadmill is in the location where it will be	6
used (see HOW TO MOVE THE TREADMILL below),
make sure that both Rear Feet (5) and both front
Wheels (not shown) rest firmly on the floor. If the tread-
mill rocks slightly, loosen the Rear Foot Locknut (111)
above the right Rear Foot. Turn the right Rear Foot		111
clockwise or counterclockwise until the rocking motion
is eliminated. Then, tighten the Rear Foot Locknut.		5
	111	5

7.Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrenches for adjustment purposes. To protect the floor or carpet from damage, place a mat under the treadmill.

HOW TO MOVE THE TREADMILL

Note: It may be helpful to leave the treadmill at an in- cline before moving the treadmill.

Before moving the treadmill, make sure that the power cord is unplugged from the wall outlet.

Due to the size and weight of the treadmill, moving it requires two persons. While one person lifts the indi- cated end, firmly hold the handrails and tip the treadmill forward until it rolls on the front wheels. Carefully move the treadmill to the desired location and then lower it.

CAUTION: To reduce the risk of injury, use extreme caution while moving the treadmill. Do not attempt to move the treadmill over uneven surfaces.

Lift	Handrails
Here
	Wheels

7